22
5.1 Cautions
Must switch off the SLA-3 device before wiring and completely
connect in compliance with the drawing
Any change is not allowed to the device circuit
Connect with power supply device complying with local law or
standards, otherwise may lead to damage or misoperation
◆
◆
◆
5 Wiring
Remark: the wiring implemented by qualied persons, in accordance
with this manual and applicable safety regulations.
The power supply device meets below requirements:
1) local veried power device
2) comply with EMS directs(for CE certication)
3) comply with low-volt directives,output power below 100VA
4) output holding time >20ms
5) when electric surge occur,need usd SPD
6) In line with CLASS 2 (comply with UL/cUL)<SUPPLYMENTARY> As
IEC 60536 regulation that the power device with double insulation or
reinforced insulation distance.Comply with low-volt directives and output
power<100VA
To Next Page
Loading...
Need help?
General
