LNTECH SLA-3 User Manual

21
Ensure the bending machine be powered off when mount the
SLA-3 protection device, otherwise may lead to serious injury.
Verify the emitter and receiver in the same horizotal and vertical
plane,E3 beam set at front of upper tool tip, the distance from
receiver and emitter to machine slider >10cm.
4.6 Installation Tools
1. electrodrill, bore bit(φ6.8)
2. screw tap(M8)
3. screwdriver
4. Allen key(6mm)
5. pointed-nose pliers

LNTECH SLA-3 Specifications

General

Brand	LNTECH
Model	SLA-3
Category	Protection Device
Language	English