Lode Valiant - Quick Start Mode Operation; Simple Start Procedure; Stopping Program Operation

Operator Manual Valiant
15
4.3.6 Quick start
(all models)
The simplest way to start the Valiant is this quick start mode. No parameters have to be filled
in and the Valiant can be started immediately by pressing Enter [3]. This test does not show
the amount of performed kilo calories.
4.3.7 Heartrate
By means of the Polar belt (necessary for heartrate controlled tests) the actual heartrate can be
seen on the actual heartrate display [10]. When the test subject is not wearing the Polar belt ,
the heartrate will not be visible.
4.3.8 Stopping a program
During a test the Valiant can be stopped by pressing Stop [4]. When this button is pressed
once:
· The angle immeditaly will decrease to 0%
· At a speed of 2.0 km/h or slower, the speed is decreased to 0 km/h
· At a speed higher then 2.0, the speed will be regulated to 40% of the last speed.
Pressing Stop again will turn the Valiant into the stand-by mode. The last parameters will be
shown.