Total Hr = Total hours the Valiant has performed
Service = Total kilometers the Valiant has performed
Belt count = Total amount of kilometers the belt has performed
Hi speed = Maximum speed of the belt.
Duration = Maximum time during 1 training
(99 = infinitive)
Brightness = brightness of the display. Recommended is 4 or 5. because of
the workload of the electronics
Display id = 0 = kilometers/ kilogram (metric system)
1 = miles/pounds (imperial system)
Prot id = Lode : Lode ERM protocol
trAck : Trackmaster communication protocol
UUood : Woodway communication protocol
HPcoS : HP Cosmos communication protocol
gE : GE communication protocol
Selection Interface rS232 : RS232 port
USb : USB port
Baudrate = 0 (Autoselect dependent on protocol-id)
4800; 9600; 19200
All values can be changed with + and – under [8]
3.6 Installation
· Do not install the unit in a location near a heat source such as a radiator.
· Avoid exposure to direct sunlight, rain, excessive dust, dampness, mechanical
vibrations and shocks.
· Cordless telephones should not be used in close proximity of the unit.
· This unit should not be used in so-called “wet-rooms” (hydrotherapy rooms).
· The unit has to be installed in such way that liquid cannot enter.
· A proper air circulation is imperative to prevent overheating, so do not leave clothing
etc. on the motor compartment cover.
Should any liquid ingress into the housing of this equipment, unplug the unit from the wall
socket (if connected) and have it checked by an authorized expert.
3.7 Moving and transport
The Valiant can be moved over small distances by lifting the backside up and rolling forward
over the small wheels at the front side.
3.8 Electromagnetic interference
To Next Page
Loading...