Operator Manual Valiant
Symbols
Read manufacturer’s guide, advises
and instructions and manual
CE
0344
marking for Medical Devices classified
as Im, IIa or IIb according to the MDD
93/42.EEC.
Tested and certified to U.S. and Canadian
National Standards by a NRTL, viz
TÜV Rheinland. Compliance for U.S. and
Canadian markets.
Warning / safety precautions Pay
attention to accompanying
instructions
Warning: do not jump onto the
rotating belt. Do not jump off the
rotating belt (not even to the front).
Don not stop moving on the
running belt. Do not turn around on
the running belt. Do not move
sideways or backwards. Do not
make movement that could get you
out of balance. Keep away from
rollers. The operator must keep
away from the footrail while
lowering.
Connector for Control Unit
Symbol for collection , treatment,
recycling and disposal of waste
electrical and electronic equipment
(WEEE) as set out in Directive
2002/96/EC of 27 January 2003 of
the European Parliament and of the
Council on waste electrical an
electronic equipment are necessary
to reduce the waste management
problems linked to the heavy
metals concerned and the flame
retardants concerned
Potential Equalization Conductor
External Control Connector
Manufacturer information
Lode BV
Zernikepark 16
NL-9747 AN Groningen,
The Netherlands
t: +31 50 571 28 11
f: +31 50 571-67 46
@: ask@lode.nl
www.lode.nl
This is the operator manual for the Lode Valiant Treadmill ergometer, which describes
the basic actions for starting up. This manual is applicable for the following Valiant
models:
932900 – starting with S/N 20122000 and further
932901, 932902, 932903, 932910, 932911, 932912 – starting with S/N 20121000 and
further
Copyright Lode BV, September 2012, all rights reserved.
To Next Page
Loading...