LOFTNESS 61 - Safety Decal Locations

To Next Page

To Previous Page

9Battle Ax Skid Loader OM

Safety Decal Locations

Check and replace any worn, torn, hard to read or

missing safety decals on your machine.

Safety Instructions

Part No. N17013

Part No. N20661

Part No. N68724

Part No. 200491

DANGER

ALWAYS OPERATE

CUTTER HEAD AS

LOW AS POSSIBLE.

LIFTING OR TILTING

BACK INCREASES

THE RISK FROM

FLYING DEBRIS.

N68724

Part No. N68716

WARNING

Rotating parts hazard.

Can cause serious

injuries or death.

Do not operate machine

without shields attached.

N68716

Part No. 4256

Main Page

Table of Contents5
Ordering Code7
Battle Ax Skid Loader (Example)7
Introduction9
Owner Information9
Warranty Policy9
Serial Number Location9
Manual Storage9
Battle Ax Features10
Safety Instructions11
Safety First11
Owner's Responsibility11
Mandatory Shut-Down Procedure12
Safety Rules12
Hydraulic Safety13
Battle Ax Skid Loader Identification14
Safety Decal Locations15
Set-Up Instructions19
Pusher Bar Assembly19
Installing the Battle Ax to the Loader20
Checking Rotor Rotation20
Checking Rotor Speed21
Skid Adjustment21
Cutter Bar Adjustment22
Operating Instructions23
Getting Started23
Operation23
Log Moving24
Hydraulic Hose Storage24
Maintenance25
General Maintenance25
Maintenance Schedule25
Lubrication26
Grease Point Location26
Overhung Load Adapter27
Removing Belt Cover28
Removing Motor Cover28
Belt Adjustment28
Maintenance (Cont'D)28
Tooth Removal and Installation29
Quadco Teeth29
Tooth Sharpening (Quadco)29
Storage30
End of Season30
Beginning of the Season30
Motor & Sheave Selection Chart31
Troubleshooting32
Parts Identification33
Battle Ax Body Assembly34
Battle Ax Body Assembly (Cont'D)36
Belt and Sheaves (Parker Motor)38
Belt and Sheaves (Muncie Motor)39
Motor Shield with Gauge (N45262)40
Hydraulics, Parker Motor with Brake42
Hydraulics, Parker Motor with Brake (Cont'D)44
Hydraulics, Parker Motor no Brake46
Hydraulics, Parker Motor no Brake (Cont'D)48
Hydraulics, Muncie Motor50
Hydraulics, Muncie Motor (Cont'D)52
Valve, Open Loop CW (N21669)54
Valve, Cross Port Relief (N34677)55
Manifold, Relief 5000 PSI, Check (200655)55
Hydraulic Motor, Variable 80Cc to 110Cc (N38488)56
Overhung Load Adapter (N51193)57
Hydraulic Motor, 62.9Cc (N34676)58
Overhung Load Adapter (N16416)59
Rotor (with Double Carbide Teeth) 61" (203047), 71" (203050)60
Rotor (with Quadco Planer Teeth) 61" (N49368), 71" (N49371)61
Rotor (with Quadco Planer Hard Surface Teeth) 61" (203177), 71" (203179)62
Rear Cutter Bar 61" (N20281), 71" (N21908)63
Manual Holder64
Machine Decals and Signs65
Appendix69
Specifications69
Dimensions70
Torque Specifications71
Inches Hardware and Lock Nuts71
Metric Hardware and Lock Nuts72

LOFTNESS 61 - Safety Decal Locations

Table of Contents