LOFTNESS 61 - Page 6

Battle Ax Skid Loader OM
Table of Contents
Maintenance (Cont’d)
Tooth Removal and Installation .................................................23
Quadco Teeth ............................................................23
Tooth Sharpening (Quadco) ....................................................23
Storage ...................................................................24
End of Season ...........................................................24
Beginning of the Season ...................................................24
Motor & Sheave Selection Chart ................................................25
Troubleshooting .............................................................26
Parts Identification
Battle Ax Body Assembly .....................................................28
Battle Ax Body Assembly (Cont’d) ..............................................30
Belt and Sheaves (Parker Motor) ................................................32
Belt and Sheaves (Muncie Motor) ...............................................33
Motor Shield with Gauge (N45262) ..............................................34
Hydraulics, Parker Motor with Brake .............................................36
Hydraulics, Parker Motor with Brake (Cont’d) ......................................38
Hydraulics, Parker Motor No Brake ..............................................40
Hydraulics, Parker Motor No Brake (Cont’d) .......................................42
Hydraulics, Muncie Motor .....................................................44
Hydraulics, Muncie Motor (Cont’d) ..............................................46
Valve, Open Loop CW (N21669) ................................................48
Valve, Cross Port Relief (N34677) ...............................................49
Manifold, Relief 5000 PSI, Check (200655) ........................................49
Hydraulic Motor, Variable 80cc to 110cc (N38488) ..................................50
Overhung Load Adapter (N51193) ...............................................51
Hydraulic Motor, 62.9cc (N34676) ...............................................52
Overhung Load Adapter (N16416) ...............................................53
Rotor (with Double Carbide Teeth) 61" (203047), 71" (203050) .........................54
Rotor (with Quadco Planer Teeth) 61" (N49368), 71" (N49371) .........................55
Rotor (with Quadco Planer Hard Surface Teeth) 61" (203177), 71" (203179) ..............56
Rear Cutter Bar 61" (N20281), 71" (N21908) .......................................57
Manual Holder ..............................................................58
Machine Decals and Signs ....................................................59
Appendix
Specifications ..............................................................63
Dimensions ................................................................64
Torque Specifications ........................................................65
Inches Hardware and Lock Nuts .............................................65
Metric Hardware and Lock Nuts .............................................66