Programming Guide
This feature allows you to change the ringing pattern when a Door Station Speaker is pressed.
DISTINCT RING is ideal if you want to distinguish between an incoming phone call and someone at
the Door Station Speaker. A distinct and different ring pattern will be produced for each Door Station.
1) PRESS
2) Listen for .
=
**0
**0
BEEPS
2
(3) BEEPS
( ) BEEPS =
The same (6 RING) pattern for all Speaker Door Station Ports
DISTINCT RINGING PATTERN (a different pattern for every Speaker Port)
(FACTORY DEFAULT)
NOTE B: y continuing to Press the Command, the system will toggle between the (6-RING DISTINCT RING pattern)./
This feature allows you to activate the Door Station caller ID display function. When the Door Station
Speaker is pressed, a Caller ID transmission is made to any connected CALL DISPLAY style
phones. (eg: DOOR 1 .... DOOR 4).
1) PRESS
2) Listen for .
=
**2
**2
BEEPS
2
(3) BEEPS
( ) BEEPS =
Door Station Caller ID is ENABLED [ON]
Door Station Caller ID is DISABLED [OFF]
(FACTORY DEFAULT)
Note: This setting is recommended if Call Display Phones are not used
NOTE B
/: y continuing to Press the Command, the system will toggle between Door Station Call Display (ON OFF)
This feature allows you to prohibit or block phone numbers from being dialed.
The user has the ability to block specific phone numbers and/or numbers that begin with a particular
sequence (eg: or ).
1976 011
1) PRESS
2) Listen for .
3) SELECT a Memory BIN Number ( )
4)
**1
**
**_
*__
(2) BEEPS
09
1
to
Listen for .(1) BEEP
(2) BEEPS will be heard for acceptance of programming.
Note: Call restriction requires 3 digits minimum. To restrict 1+ long distance number you will have to enter
To block any other one digit number you simply enter plus the one digit starting number. For a 2 digit number
restriction you will enter plus the 2 digits you wish to restrict.
To DELETE a Call Restriction Programmed Number from a Memory Bin you must performs STEPS 1,2,3,4 and 6 (eliminating
STEP 5). This will remove the restricted number. (3) BEEPS will confirm deleted memory bin. Repeat STEPS 1-6 to re-enable
a number restriction.
) Enter the Phone Number to restrict 1
) PRESS to SAVE
5
6
__
#
..... 30 (up to 30 Digits) * see note below
PRESS to go into programming mode
**
*#0 (Listen for (2) Beeps)
MUST BE ENTERED WITHIN 5 SECONDS OF GOING OFFHOOK
ENTER passcode 1111
(Listen for (2) Beeps) (Default Passcode)
Page 13
NOTE: When Entering any programming functions, you have up to 30 seconds idle time before the system
will hang up at which point any programming started will not be saved
Call Restriction Phone Number Programming **1
Ring Pattern Configuration **0
Door Station Caller ID Configuration **2
Continued
on Page-14
Pick up phone handset and listen for dial tone.
To Next Page
Loading...