Page 1
Safety instructions and Guildlines
A factory default on the unit must be performed prior to initial
use. SEE PAGE 16
PLEASE VERIFY THAT YOUR TELEPHONE SYSTEM COMPLIES WITH A TYPICAL 95
VOLTS RMS @ 20 Hz RING. IF INSTALLED WITHOUT VERIFICATION
TELEPHONE EQUIPMEN
, THIS PRODUCT
MAY CAUSE DAMAGE TO T. IF YOUR TELEPHONE SYSTEM
DOES NOT MEET THE ABOVE REQUIREMENTS PLEASE CONTACT LOGENEX
INNOVATIONS INC. FOR FURTHER INFORMATION.
NOTICE
SAFETY INSTRUCTIONS
When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of
fire, electric shock and injury to persons, including the following:
1. Read and understand all instructions.
2. Follow all warnings and instructions marked on the product.
3. Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use
a damp cloth for cleaning.
4. Do not use or expose this product to direct water contact: ie: near a bathtub, wash bowl, kitchen sink, laundry
tub, in a wet basement, or near a swimming pool.
5. Dropping this product may result in serious damage to the product.
6. This product should never be operated near or over a radiator or heat register. This product should not be
placed in a built-in installation unless proper ventilation is provided.
7. This product should be operated only from the type of power source indicated on the marking label. If you
are not sure of power supply to your home, consult your dealer or local Power Company.
8. Do not allow anything to rest on the power cord. Do not locate this product where the cord will be abused by
persons walking on it.
9. Do not overload wall outlets and extension cords as this can result in risk of fire or electric shock.
10. Never push objects of any kind into this product through cabinet slots as they may touch dangerous voltage
points or short out parts that could result in a risk of fire or electric shock. Never spill liquid of any kind on the
product.
11. To reduce the risk of electric shock, do not dissemble this product, but take it to qualified service technician
when some service or repair is required. Opening or removing covers may expose you to dangerous
voltages or other risks. Incorrect re-assembly can cause electric shock when the appliance is subsequently
used.
12. Unplug this product from the wall outlet and refer servicing to a qualified service personnel under the
following conditions:
* When the power supply cord or plug is damaged or frayed.
* If liquid has been spilled into the product.
* If the control unit has been exposed to rain or water.
* If the product does not operate normally by following the instructions. Adjust only those controls that
are covered by the operating instructions because improper adjustment of other controls may result in
damage and will require extensive work by a qualified technician to restore to normal operation.
* If the product has been dropped or the housing has been damaged.
* If the product exhibits a distinct change in performance.
13. Avoid using a telephone (other than cordless type) during an electrical storm. There may be a remote risk of
electric shock from lightning.
14. Do not use the telephone to report a gas leak near the source of the leak.
15. This device may cause harmful interference.
16. This device may be susceptible to any interference including interference that may cause undesired
operation.
Complies with Part 68, FCC Rules FCC REG NO. 5ERCAN-31264-OT-N REN: 0.5B
To Next Page
Loading...