34
UNIT SETTING
Use the UNIT button to change the unit of the readings on the console display.
1. Press and hold the UNIT button for two (2) seconds to enter the unit setting mode.
2. Press the UNIT button to proceed to the next setting step.
3. Press the ^/MOD or v/NDX button to change the value. Press and hold the button to
change the value quickly.
4. Press and hold UNIT button for two (2) seconds to exit the unit setting mode at any time.
Step Mode How to adjust
1 Temperature unit Press ^/MOD or v/NDX button to select °C or °F.
2 Light intensity unit Press ^/MOD or v/NDX button to select Klux, Kfc, or W/m2.
3 Wind speed unit Press ^/MOD or v/NDX button to select m/s, km/h, knots,
or mph.
4 Baro pressure unit Press ^/MOD or v/NDX button to select hPa, inHg, or mmHg.
5 Rain unit Press ^/MOD or v/NDX button to select mm or in.
6 Distance unit Press ^/MOD or v/NDX button to select km or mi.
7 HCHO unit Press ^/MOD or v/NDX button to select ppb or mg/m3.
8 CO
2
unit Press ^/MOD or v/NDX button to select ppm or mg/m3.
9 CO unit Press ^/MOD or v/NDX button to select ppm or mg/m3.
10 Exit setting mode Press the UNIT button once more to exit.
To Next Page
Loading...
