USER MANUAL SMARTneo // PAGE 29
10.8 CHANGE OF THE DISPLAY UNIT (CM OR INCHES)
This function can be used to switch the unit of the display of the memory hand control from centimetres to
inches and vice versa. The table height itself is not changed by this function.
1
2
Simultaneously press the memory position buttons 1, 2 and the button Table top up.
Hold the button combination for approx. 3 seconds. Then release the buttons.
S 7
The display shows S and a number, e.g. S 7.
Press the button Table top up until the display shows S 5.
S 5
The display shows S 5.
SAVE
Press the memory button.
If the display was previously set to cm, it is now set to inches.
If the display was previously set to inches, it is now set to cm
NOTICE
The menu has a time-out of 5 seconds, which means that the
menu is closed automatically and without saving the settings if
no entry is made within 5 seconds.
NOTICE
When the menu appears, the display shows S and a number,
e.g. S 7. The number depends on the parameters of the control.
To Next Page
Loading...
Need help?
General
