16
To view the name of a button, press it as you normally would. Its name is displayed in
thecentreline of the MFD.
If a game is in progress, use the clutch to deactivate the buttons in the game. You can then
press them and view their names without aecting the game. When supplied, the clutch
is set up so that you must keep it depressed for as long as you want the buttons to remain
inactive in the current game. You can change the way the clutch button works via the MFD
tab of the Logitech G X52 Professional HOTAS properties window. See Changing the way
your clutch button works in Maintaining your controller settings for details.
Note: You cannot view button names if the properties window is open.
Changing the current prole
You can use the MFD to change the current prole ’on the y’. You may, for example,
realisethat you’re not working in the correct prole for the game in progress.
To change the prole on the y
1. Press the clutch button. The LEDs on your clutch and on the main POV control on
youright stick begin to ash on and o. Pressing buttons does not aect the game in
progress when the clutch is engaged.
2. Move the main POV control on your ight stick up (north) or down (south) to scroll
through your proles. As you do this, the prole names are displayed in the bottom row
of the centre section of the MFD.
Note: You can use the MFD to access any folder on your computer. To open a folder,
pushthe POV to the right (east). To move up a level, scroll through the les and folders
in the current folder until [...] is displayed,
and then push the POV to the right (east).
3. Select the prole you want by moving the
main POV control right (east) when the
prole’s name is displayed on the MFD.
It becomes the current prole and its settings are applied when you resume the game
inprogress.
Tip: You can clear the current prole by moving the POV left (west). The buttons on
yourstick and throttle return to their default settings.
To Next Page
Loading...
Need help?
General
