Do you have a question about the Logitech G735 and is the answer not in the manual?
Wireless Technology | LIGHTSPEED Wireless, Bluetooth |
---|---|
Compatibility | PC, Mac, PlayStation, Nintendo Switch, Mobile |
Surround Sound | DTS Headphone:X 2.0 |
Type | Over-ear |
Impedance | 38 Ohms |
Driver Size | 40 mm |
Frequency Response | 20 Hz - 20 kHz |
Weight | 259 g |
Sensitivity | 87.5 dB SPL/mW |
Microphone Frequency Response | 100 Hz - 10 kHz |
Microphone Polar Pattern | Cardioid (unidirectional) |
Microphone | Yes, detachable |
Connectivity | Wireless, 3.5mm wired |
Wireless Range | 20 m |
Lighting | RGB |
Battery Life | Up to 16 hours with lighting, up to 56 hours without lighting |
Insert the microphone connector into the port on the left ear cup. It is designed to fit in one way.
Turn on the G735 headset by pressing and holding the power button located on the left ear cup for 3 seconds.
Insert the LIGHTSPEED receiver, with extender and cable into the PC USB port.
Download and install G HUB software to your PC/MAC for the best gaming experience. Go to www.logitechG.com/ghub.
Turn on the G735 headset by pressing and holding the power button for 3 seconds.
Press Connectivity button to select Bluetooth® – the indicator light above will turn blue.
Press and hold Connectivity button for 3 seconds to initiate pairing mode. The blue light will flash quickly.
Follow Bluetooth® connection for your device to pair with the headset.
Adjust volume with the roller on the left ear cup. This adjusts the headset's total volume.
Press the mute button below the volume on the left ear cup to mute the microphone. RGB will flash red when muted.
G735 can connect to and mix multiple audio sources like LIGHTSPEED, Bluetooth®, and Auxiliary audio.
Toggle between LIGHTSPEED and AUX options by pressing the connectivity button on the right ear cup.
Press up/down buttons on the right ear cup to adjust balance between LIGHTSPEED/AUX and Bluetooth® sources.
Press and hold both buttons for 3 seconds to reset to equal audio levels.
Turn off G735 headset by pressing the power button on the left ear cup for 3 seconds. It will auto shut off.
Short press the power button to check battery status: Green (>30%), Red (<30%), Blink Red (<15%).
Double press the power button on the left ear cup to turn off the cosmetic lighting.
Plug the USB-C cable into the left ear cup and USB-A into a PC or charging adapter. Power light shows charging status.
Ear pads can be removed and replaced.