Logitech Harmony Ultimate
34
4. Tap Hub assignments.
5. Select a device that you want to control using your Harmony Ultimate remote and not the hub or IR mini
blasters.
6. A menu of options for how to control the device is displayed.
7. Select Remote only.
Once you have set up your remote like this, it will prompt you to keep your remote pointed at your devices until it is
finished sending commands to your devices. Depending on your Activity, the Harmony Ultimate may send power
commands to your devices very rapidly after the Activity is launched. Keeping the remote carefully pointed at your
devices immediately after starting an Activity will help ensure the power and other commands reach your devices
successfully.
The Harmony Hub and connected IR mini blasters will by default all send infrared commands to your devices.
The Hub assignments menu mentioned above can be used to specify which of the Harmony Hub or IR mini blasters
should control specific devices, helping to optimize your system.
For example, if IR mini blaster 1 is placed inside your entertainment cabinet, assign all the devices in that cabinet (or
on that specific shelf) to be controlled by IR mini blaster 1. Only that IR mini blaster will send infrared to those
devices.
TIP: Devices controlled using the Harmony Ultimate remote and not the hub or IR mini blasters
require that you keep the remote pointed at them when starting an Activity, sending commands, or
using the Help feature.
Use the Help function to put the remote back in sync with devices
Sometimes Harmony becomes out of sync with your devices and confuses when they are on or off, or which input
they are on. This occurs when there is an obstacle between the device and the IR transmitters in the hub, IR mini
blaster, or remote; or if the devices are operated manually or by using their original remote control.
1. Harmony Ultimate can run through a series of questions to help identify the issue and correct it. Tap the
icon.
2. Select Help.
3. Answer Yes or No to the questions on the screen.
Based on your answers, your remote re-sends the necessary commands to synchronize it with your devices.
NOTE: If you use the Help feature frequently when powering on your devices or switching between
Activities, then there may be changes that can be applied to correct this. The Help feature should not
be necessary with a properly configured setup.
TIP: Before you use Help, make sure you take steps to address the problem: remove any obstacles
from the line of sight between your remote and your system, and only use the remote when it is
within range of your entertainment system.
For more information about using the on-remote Help feature, refer to the Harmony Ultimate On-Remote Help
FAQ.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
