logitrans LOGIFLEX SELF MAXI - Maintenance for Longevity; Lubrication and Hydraulic Oil

- 15 -
Regular inspection and the replacement of worn or defective parts in good time will
prolongthelifeoftheLogiexMaxi.“Preventionisbetterthanrepair”,thereforeensure:
- Correct usage
- Regular cleaning
- Periodic safety and service inspection (see the back page)
- Due to safety reasons, the below points have to be checked every 3 months:
- Loose screws and nuts have to be tightened up.
- Breaches, cracks or deformations are not allowed on the load-bearing parts.
- Wearing parts, such as brakes, wheels and bearings, are to be adjusted
or changed continuously
- The lifting chains are to be checked, see 6.6
6.1 Lubrication and hydraulic oil
 UndernormaloperationconditionstheLogiexMaxirequiresno
lubrication.
All ball bearings are sealed and lubricated for life, and moving parts
have self-lubricating bearings or are treated with grease. The hydraulic
 systemislledwithhydraulicoilofviscosityclassISOVG15.
An additive is added to the oil. The concentrate reduces friction and wear and
protects against corrosion. Pre-mixed hydraulic oil with additive is available from the
dealer. To ensure that the cylinder pipe is lubricated and thereby protected angainst
corrosion, it is important to lift the forks to top position frequently. The oil is suitable
for use in the temperature range -10° to +50° C. A thinner oil is recommended for
temperatures lower than -10° C (if necessary, contact your dealer).
6.0 Long live Logiflex Maxi