27
Regular inspection and the replacement of worn or defective parts in good time will
prolong the life of the Rotator. “Prevention is better than repair”, therefore ensure:
• That the battery is fully charged every time
• Correct usage
• Regular cleaning
• Periodic safety and service inspection (see the back page)
Due to safety reasons, the below points have to be checked every 3 months:
• Loose screws and nuts have to be tightened up.
• Breaches, cracks or deformations are not allowed on the load-bearing parts.
• Wearing parts, such as brakes, wheels and bearings, are to be adjusted or
changed continuously
6.1 Lubrication and hydraulic oil
Under normal operation conditions the Rotator requires no lubrication.
All ball bearings are sealed and lubricated for life, and moving parts
have self-lubricating bearings or are treated with grease.The hydraulic
system is lled with hydraulic oil of viscosity class ISO VG 15.
An additive is added to the oil. The concentrate reduces friction and
wear and protects against corrosion. Pre-mixed hydraulic oil with additive is
available from the dealer. The oil is suitable for use in the temperature range -10
to +50° C. A thinner oil is recommended for temperatures lower than -10° C (if
necessary, contact your dealer).
6.0 Long live the Rotator
To Next Page
Loading...
