LONCIN LC3500i - Low Power

Chapter IV Disassembly & Repair
- 13 -
4-1-2 Low power
(Refer to Section 4-5-2)
(Refer to Section 4-4-1)
(Clean)
(Refer to Section 4-5-4)
(Refer to Section 4-4-4)
(Under the “operation” position)
(Refer to Section 3-3)
(Refer to Section 4-4-3)
(Refer to Section 3-6)
(Refer to Section 4-4-1)
(Refer to Section 3-7)
(Clean)
(Refer to Section 4-4-2)
(Refer to Section 3-4)
Low power
Fuel system
Ignition system
Compression
system
Improper adjustment of carburetor
Fuel filter blocked
Choke-valve handle not opened completely
Air filter dirty
Fault of spark plug cap
Fault of ignition coil
Wear of cylinder/piston/piston ring
Improper adjustment of valve clearance
Cooling fan dirty
Wear or damage of valve seat
Cylinder cooling fin dirty
Silencer blocked
Motor phase loss & short circuit for some
turn-to-turn of machine winding
Others
(Use new fuel oil of specified quality)
Poor quality of fuel oil
(Disconnect surplus load)
Excessive electrical load
Wear of camshaft