EasyManua.ls Logo

Lonking CDM307 - Page 43

Lonking CDM307
81 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CHAPTER III MACHINE OPERATION
37
the diesel engines maintenance instruction requested correct power adjusts its actual power, to ensure
the proper use of Skid Steer Loader.
3.2.1.8 In order to improve the hot and cold regions loader operator comfort, equipped with air
conditioner on request.
3.2.1.9 In cold weather, do not use heater when the engine starts, wait for the engine is running
(warm), and the water temperature above 78
ā„ƒ
then turn on the heater switch so as not to affect the
heating effect.
3.2.2 THE RIGHT WAY OF IN AND OUT OF LOADER
When sliding in and out of the cab do not jump up or down, may result in personal injury. To adopt
the correct way in and out of the cab. Lower the boom to the ground before in and out the cab. As shown,
using handrails (fixed in front of the cab ) and the pedal (fixed in the lifting arm) into the cab, remember to
keep the handrails and pedals clean to avoid oil, caused slipping and personal injury. If the operator
leave the cab when the lift arm raised, lock the boom lock pin and stop the engine
.
Figure 12 CORRECT WAY FOR MOUNTING THE MACHINE

Related product manuals