Lonking CDM307 - Page 77

CHAPTER VI COMMON FAULTS AND TROUBLESHOOTING
71
obstructed

Traveling motor fault

The brake light is always
on

Repair or replace

Inspect the seat switch and
safety rod switch.
Machine moves
slowly(with abnormal
sound)

Oil level is too low

There is spume.

Oil suction pipe is too
small

Suction filter plug

Traveling motor fault

Parking brake indicator is
on.

Fuel

Use pulsive oil

Inspect and remove leak

Assemble again

Repair or replace

Inspect the switch of the
seat and the safety rod.
Traction force in both
directions is not
enough.
 The engine do not reach
to max.speed.
 Donkey fuel pump fault
(gear pump)
 The max.speed setting of
valve is incorrect.
 Setting of release valve is
not corrected
 Oil overheating
 Traveling motor fault
 Replace diesel filter and
inspect injector pump
 Repair or replace
 Restart
 Restart
 Inspect oil level and clean
radiator
 Repair or replace
Traction force in only
one direction is not
enough.
 Engine overload
 The pressure setting in
this direction is incorrect.
 Reducing load
 Adjusting valve
Oil overheating
 Oil level is too low
 Radiator is plugged or
dirty.
 Oil is not suitable
 Oil suction pip is too small
 Max.pressure of adjusting
valve
 Traveling motor fault
 The setting of release is
too much.
 Traveling motor fault
 Fuel
 Inspect, replace if
necessary
 Replace correct oil
 Inspect and remove leak
 Inspect mounting, repair or
replace
 Repair or replace
 Adjusting valve
 Repair or replace
The machine can not
reach at the
max.speed.

Filter is pluged

The engine do not reach
to the max.speed.

Travelling pump fault.

The setting of the oil relief
valve is incorrect.

Replace

Replace diesel filter and
inspect the injector pump

Inspect, repair or replace

Adjust