17
EN
CAUTION : Do not apply force at any time as this
may cause irreparable damage.
2 I Rotate the crankset to pre-position the right hand
bearing in its seat.
1 I Insert the crankset into the frame, starting with
the left hand crank arm.
3 I In a smooth and linear movement, slide the whole
crankset leftward to bring the right hand bearing into
its seat.
4 I Prepare the locking ring by inserting the
mounting aid into the 1mm slit and locking it in using
the M3x30mm screw.
5 I Slide the above ring + aid + screw combination
over the left-hand crank and lightly screw the ring
onto the crankset thread.
6 I Fit a 2.5 Allen key into the hole opposite the M3
screw for additional leverage, and tighten the ring.
To Next Page
Loading...
