13
EN
MOUNTING THE HANDLEBAR ON THE STEM
1 I Degrease the face plate (10), the handlebars (9)
and the stem (7).
2 I Grease the M5x30 screw (8) threads and heads.
3 I Place the barrel in the face plate. The barrel sits
under the stem (see diagram opposite).
4 I Pre-position the handlebar in the stem.
5 I Place the lower part of the face plate against
the stem.
6 I Fold the upper part of the face plate onto the
stem.
7 I Fit the stem screws (CHC M5x30 coated in
threadlocker such as LOCTITE 243) into the stem
from above and tighten to a torque of 8Nm using a
torque wrench tted with an Allen HEX4 head.
Approved handlebar width : 31.8mm. Minimum clamp area width: 45mm.
To Next Page
Loading...
