23
EN
1 I Grease the surfaces of the wedge sections and
the lower half of the wedge bolt as indicated in the
illustration opposite.
2 I In order to prevent slippage, degrease the
surfaces that will be in contact with the seatpost.
3 I Slide the loosened wedge into position inside the
frame.
INSTALLING THE SEATPOST
The seatpost is supported on a stopper inside the seat tube, and held in position by a wedge.
INSTALLATION PROCEDURE
1 Center wedge x1
2 Upper wedge x1
3 Lower wedge x1
4 FHC M6x30 screw - 8Nm x1
To Next Page
Loading...
