25
EN
7 I If necessary, you will nd 15 1mm spacers in
the case delivered with the bike. They can be used
following a change in the rider’s position and must
be placed between the seat post and the stop in the
seat tube.
CAUTION : It is forbidden to use more than
15 spacers per bike as the minimal seatpost
insertion length would no longer be met. This
could pose a serious risk to the rider.
INSTALLING THE REAR WHEEL
n the case delivered with your bike you will nd the ttings required to install and tighten the rear wheel.
These ttings allow you to mount a Ø12mm, at seat thru axle or a standard axle depending on the type of
wheels used.
The bike is tted with adjustment rollers and screws on each rear dropout.
To Next Page
Loading...
