Declaration of conformity
909.2049.9-00 - 27 -01.14
18 Accessories
See gures
IX
19 Maintenance and repair
Please heed the current safety and ac-
cident prevention regulations during all
maintenance and repair work.
The machine requires a minimum of care and mainte-
nance. Only a few items need to be checked to ensure
trouble-free long-term operation.
19.1 Check regularly
Check the following points for damage before starting
up the welding machine:
– Mains plug and cable
– Welding torch and connections
– Ground cable and connection
– Keyboard membrane and control panel
Blow the welding machine out once or twice a year.
 To do this, switch the device and disconnect the mains
plug.
 Using dry compressed air, blow the welding machine
out from the front through the ventilation slots. Leave
the housing closed.
Never blow the compressed air through the
ventilation holes on the rear side of the ma-
chine. The fan is located there and the com-
pressed air would make it turn so quickly that
bearing damage may result.
20 Disposal
Only for EU countries.
Do not dispose of electric tools together with
household waste material!
In observance of European Directive 2002/96/EC on
waste, electrical and electronic equipment and its imple-
mentation in accordance with national law, electric tools
that have reached the end of their service life must be
collected separately and returned to an environmentally
compatible recycling facility.
21 Service
Lorch Schweißtechnik GmbH
Im Anwänder 24 - 26
D-71547 Auenwald
Germany
Tel. +49 (0)7191 503-0
Fax +49(0)7191 503-199
22 Declaration of conformity
We herewith declare that this product was manufactured
in conformance with the following standards or ofcial
documents: EN 60 974, EN 61 000-3-2, EN 61 000-3-3
in conformance with the guidelines 2006/95/EC,
2004/108/EC, 2011/65/EU.
2013
Wolfgang Grüb
Managing Director
Lorch Schweißtechnik GmbH
To Next Page
Loading...
Need help?
General
