LORD D4 - Tension adjustment of the door spring; Dishwasher installation steps

21
Step 3. Tension adjustment of the door spring
(valid only for D4 model)
1. Thedoorspringsaresetatthefactorytothe
propertensionfortheouterdoor.Ifaesthetic
woodenpanelareinstalled,youwillhaveto
adjustthedoorspringtension.
 Rotatetheadjustingscrewtodrivetheadjustor
tostrainorrelaxthesteelcable.
2. Doorspringtensioniscorrectwhenthedoor
remainshorizontalinthefullyopenedposition,
yetrisestoaclosewiththeslightliftofanger.
Step 4. Dishwasher installation steps
Pleaserefertothespeciedinstallationstepsintheinstallationdrawings.
1. Axthecondensationstripundertheworksurfaceofcabinet.Pleaseensurethe
condensationstripisushwithedgeofworksurface.(Step2)
2. Connecttheinlethosetothecoldwatersupply.
3. Connectthedrainhose.
4. Connectthepowercord.
5. Placethedishwasherintoposition.(Step4)
6. Levelthedishwasher.Therearfootcanbeadjustedfromthefrontofthe
dishwasherbyturningthePhilipsscrewinthemiddleofthebaseofdishwasher
useanPhilipsscrew.Toadjustthefrontfeet,useaatscrewdriverandturnthe
frontfeetuntilthedishwasherislevel.(Step5toStep6)
7. Installthefurnituredoortotheouterdoorofthedishwasher.(Step7toStep10)
8. AdjustthetensionofthedoorspringsbyusinganAllenkeyturninginaclockwise
motiontotightentheleftandrightdoorsprings.Failuretodothiscouldcause
damagetoyourdishwasher.(Step11)