EasyManuals Logo

Lorentz PS2-600 C User Manual

Lorentz PS2-600 C
80 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #35 background imageLoading...
Page #35 background image
8.1.2 Cable Splicing
To connect the motor cable with a cable extension you
should connect the cable ends with a splicing kit.
It is very important that the cable joints are fully sealed oth-
erwise moisture could cause a short circuit. This will damage
the pump system.
For more information about connecting cable ends with a
splicing kit see the “submersible cable splicing” manual in
the package of the splicing kit.
CAUTION – Cable splice failures are a
common source of errors. Check the splice
for proper connections.
CAUTION – Bad cable splicing can
damage the controller and/or the pump.
Such damage is excluded from the
warranty.
8.2 Pump System Type
Depending on your pump system, please refer to the correct
chapter for installation instructions:
Pump type Chapter
Submersible 8.3
Surface CS-F 8.4
Surface Boost 8.3
To determine the type of system you have, please refer to
chapter “3.4 Naming” on page 8.
32 Pump Installation
Pump Installation 33

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lorentz PS2-600 C and is the answer not in the manual?

Lorentz PS2-600 C Specifications

General IconGeneral
BrandLorentz
ModelPS2-600 C
CategoryWater Pump
LanguageEnglish

Related product manuals