existing
prcgEmming
from all thtee buflons,
carry
out the fol-
1. P€ss
and
hold
the two outer buttons, I and lll, for aboul 20
seconds untilthe LED begins to flash.
2. Release both buttons.
The Homelinksystem is now in seiting mode(lraining mode)
and can
be reprogrammed as delailed above. For secu ty
reasons, il is recommend€d lo etas€ all
prograrnming
before
selling
lhe vehacle.
Diagnostics
lf, aftercarefully reading
and
following
the above instructions,
you
still cannot successiully train
your
Homelink to
your
o
ginal
remote control,
assistance
is
available via the tollfree Johnson
Controls Customer Service Hotlin€ 008000 466 35465 or
+49
6838 907-277.
Before
calling, ensurethal
you
have the following
infomation availabls to assist lh€ Hotline operator:
1. To
determine the Softw€re Revlslon ol
your
Homelink,
press
and hold 6ilh€rbutton lor lllinol both)for aboul100 seconds,
atwhich
pointthe
LED willstop flashinq and tum ofi. Continue
to holdth€ button
p.essed
unlilthe LED begins flashing the
revision veFion number.
Forexample, seven flashes would
mean Rev,sio, 20,
2. To delermine the Regrbr
Code slatus of
your
Homelink,
press
and hold butlon 1l ior about 100 seconds, at which
point
the
LED willsbpnashing and tum off. Continueto hold
the
bul.
ton
pressed
untilthe LED beqins flashing the reqion code:
1 flashi Resl of Europe
2 flashesi Frcnce
3flashesr U.K.
4 flashesi llaly
3. Additionally, the Hotline will requesl from
you
lhe following
information aboul
your
vehicle and the original transmitter
you
are
trying to
programme:
- Make and model of
your
vehicl6, including
year
of manufac-
lure, country of
purchase
and Vehicle ldentilic€tion Number
(vr.N.)
- Original remote control brand, model, age and operating
frequency,
if known.
To Previous Page
