LOUP ELECTRONICS
•
1-877-489-5687
•
WWW.LOUPELECTRONICS.COM
5
2.11 CROp/vARIETY
Selecting the Crop Icon from the lower
right of the Main Screen will load the Crop
Details page where the Crop type can be
changed or the Variety entered. Select the “Selected Crop” button
to bring up the crop selection window. To enter a Variety, select
the “Crop Variety” button and enter the variety name through
the on-screen keypad.
2.12 TAsks AND TAsk sTATus
Selecting the Farm/Field button will bring you to the
Tasks & Logging screen. From here you can enter a task
name, start a new task log, or resume a previous log
from the SD card.
e Play or Stop button shown on the Main screen indicates
the status of the current Task. Pressing the Green Play button
will start the task, while the Red Stop button will stop the
current Task.
3.0 TaSkS & logging
To access the Tasks/Logging screen select the Farm/Field Button
or by selecting “Menu” and “Tasks & Logging”.
3.1 ENTERINg A TAsk NAME
Begin a new task by rst entering the
task name you desire. Select the task
name button and using the keyboard
enter the name you wish followed by the enter key.
3.2 fARM & fIELD NAMEs
Below the Task Name you
will nd the Farm and
Field names. Selecting
the Farm name and/or
Field name will load the
keyboard allowing you to type in a new Farm or Field name.
3.3 CROp & vARIETY
Below the Farm/Field names will be the Crop and Variety
currently selected. Pressing this option wll bring you to the Crop
information screen where you can select a dierent crop or enter
a dierent crop variety. Select “Exit & Save” to return to the
Tasks screen. You can also access this screen directly by selecting
the Crop button on the Main Screen.
3.4 sTARTINg A TAsk
When the Task Name, Farm, Field and Crop
information is entered correctly, push the
“Start Task” button to begin logging the task.
Once started the SD Card icon, GPS icon will appear on
the top of the screen to conrm the task is currently running and
saving to your SD card. You’ll also notice the Play button
changing to a Stop Button
Note: If no SD card is present, insert the SD card on the right
side of the monitor, securely close side-cover and cycle
the power to the Elite monitor.
3.5 sTOppINg A TAsk
Use the Stop Button
on the main screen to stop the current
task. With a log stopped you can then perform a Yield Nudge or
select the Farm/Field button to start a new task.
Note: Its important the task be stopped prior to removing the
SD card or turning o the monitor.
To Next Page
Loading...
Need help?
General