122
The Transfer My Data submenu asks if you want to save data to the
MMC or load data from the MMC into the Unit's memory.
2. The Transfer My Data menu includes a message which tells you if an
MMC is present or not. If no MMC is present, you must first insert a
card into the Unit in order to activate the Load or Save commands.
To transfer data from the Unit to the MMC: press
ENT
(for
S
AVE
.)
To transfer data from the MMC to the Unit: press → to
L
OAD
|
ENT
.
3. Saving to MMC: To accept the default name "Data" for the GPS
Data File, press ↓ to
S
AVE
D
ATA
|
ENT
. If you wish to rename the file (as
shown in the following figures), press
ENT
to activate the selection box.
Press ↑ or ↓ to change the first character, then press → to the next
character and repeat until the name is correct. Then, press
ENT
|↓ to
S
AVE
D
ATA
|
ENT
.
The unit will display first a progress then a completion message when
the data transfer is finished. To return to the Page view, repeatedly
press
EXIT
.
From left to right, these figures show the menu sequence for naming and
saving a GPS Data File from the Unit's memory to an MMC.
To Next Page
Loading...
Need help?
General
