4 -3
7. If you press brake pedal or push down
cruise control lever, the cruise control mode
shall be released.
6. If you pull the cruise control lever up, the
tractor will move at constant speed.
1. Pull the position control lever to lift the
implement up after starting engine
2. Set engine speed at 1500 rev/min.
3. Place the range shift lever in desired
position.
4. Press the brake pedal and release the
parking brake.
5. Press the HST pedal slowly forward or
backward to move the tractor.
4-2. How to drive and how to stop
(1) How to drive
▶For HST model, there is a switch to control engine cut-off for driver’s safety. If the
operator leaves the driver’s seat without proper action for safety, the engine shall
be stop automatically. (For further information about seat, see page 2-2)
▶ When you drive HST type tractor, run the engine speed more than 1500 rev/min
for stability of hydraulic system.
▶ Press the HST pedal forward or backward slowly to prevent the sudden start of the
tractor.
Notice
HST type
Position control
lever
Range gear lever
Throttle lever
HST pedals
Cruise control lever
Cruise drive
To Next Page
Loading...
Need help?
General
