5 -13
(1) Lubricating grease
z Threads, pin-connection parts and other sliding or
moving parts.
5-6. Every 50 hour check
▶ The contaminated oil may reduce the durability of transmission and cause the
failure of hydraulic system. Clean around oil filling port and then open the cap.
Caution
Oil gauge
(2) Cleaning of Radiator and Radiator screen
z (See page 5-10)
(3) Checking Transmission oil
z Stop the tractor on level surface and apply the
parking brake and lower implements to the
ground.
z Clean around oil filling inlet and pull the gauge
straight out.
z Check If the oil level is between MAX and MIN of
oil gauge. If necessary, add new oil.
z For oil specification, refer to “Lubricants and
Capacity” at the end of this manual.
(or See page 5-4)
To Next Page
Loading...
