LSI MegaRAID SAS 9271-4i User Manual

LSI Corporation
- 5 -
MegaRAID SAS 9271-4i and SAS 9271-8i RAID Controllers Quick Installation Guide
June 2012
MegaRAID SAS 9271-4i and MegaRAID SAS 9271-8i RAID Controllers
2 Installing the RAID Controller
1. Unpack the RAID controller.
Unpack the RAID controller in a static-free environment. Remove it from the antistatic bag, and inspect it for
damage. If the RAID controller appears to be damaged, or if the MegaRAID Universal Software Suite CD is missing,
contact LSI or your MegaRAID OEM support representative.
The CD contains utility programs, device drivers for various operating systems, and the following documentation:
— 6Gb/s MegaRAID SAS RAID Controllers User Guide
— MegaRAID SAS Software User Guide
— MegaRAID SAS Device Driver Installation User Guide
— Cache Backup Products for MegaRAID SAS+SATA RAID Controllers User Guide
— MegaRAID LSIiBBU09 Intelligent Battery Backup Unit Quick Installation Guide
— Software license agreement
2. Prepare the computer.
Turn off the computer, and unplug the power cords from the rear of the power supply. Remove the cover from
the computer.
3. Review the jumpers and the connectors.
The following figure shows the location of the jumpers and the connectors on the RAID controller. The jumpers
are set at the factory, and you usually do not need to change them.
Figure 2 Layout of the MegaRAID SAS 9271-8i RAID Controller
CAUTION Back up your data before changing your system configuration. Otherwise, you might lose data.
CAUTION Before you install the RAID controller, make sure that the computer is disconnected from the
power and from any networks.
3_00890-01
J3A1
J4B1
J3L1
J5A2
J6B3 J6B5
J6B6
J6B4
J6B2
J6B1
J1A3
J2B4
J1A2
J1A4
J1B1
J5A1
J5B1

LSI MegaRAID SAS 9271-4i Specifications

General

Brand	LSI
Model	MegaRAID SAS 9271-4i
Category	Controller
Language	English