LSIS iXP Series - Page 23

Chapter 2 System Configuration
2-6
Device setting switch is made up of followings;
Be sure not to flip switches Nos. 2, 5, and 6 toward A at the same time. Normally it is recommended to set switch No.2 toward A.
If you boot it with switches Nos. 2, 5, and 6 to A at the same time, it may cause malfunction of booting sequence resulting in
white screen and abnormal booting.
2.2 System Configuration
(1) PC and its Construction
In order to use XGT Panel, it is necessary for XP-Builder to prepare project data and transmit it to XGT Panel.
Normally you can connect with XGT Panel using USB 2.0 Device. Maximum Communication speed is 480Mbps.
With Ethernet in use, you can transfer project data more quickly.
With LAN environment built in the following configuration, you may use it more easily and effectively.
Pin
Number
Configuration
Function
No.1
Reserved
No.2
A Config.
NAND FLASH is used for booting (default)
B Config.
NAND FLASH is not used for booting
No.3
A Config.
BACK UP BATTERY On
B Config.
BACK UP BATTERY Off (default)
No.4
A Config.
Watchdog function On (default)
B Config.
Watchdog function Off
No.5
A Config.
SD Card is used for booting
B Config.
SD Card is not used for booting (default)
No.6
A Config.
USB, UART is used for booting
B Config.
USB, UART is not used for booting (default)
USB Cable
USB Device
Ethernet hub
iXP Series
iXP Series
iXP Series
USB Host 2.0
PC
PC