Chapter 12. EMC Standard Certification
Directive:
Electromagnetic Compatibility Directive 89/336/EEC amended by the Directive 93/68/EEC
12.1.2 KC standard certification
The XGT Panel acquire the electromagnetic fitness registration (KC specification) certified by wave laboratory under information-
communication part.
A grade device
This device acquires KC for industrial use.
If device is not purchased properly, exchange it to device for home use.
12.2 Requirement for Low Voltage Command Suitability
It is required to get the needed Stability for the device operated at AC50~1000V, DC75~1500V’s power. The following describes
attention about installation and wiring for the suitability when using the XGT Panel. Though the following data is made by requirement
of regulation and standard, we don’t guarantee that all devices are suitable for the above command. The method to be suitable for the
EMC command and judgment of suitability should be finally made by device manufacturer himself.
12.2.1 Standard certification for XGT Panel
XGT Panel is according to the EN61131-2:2007 (stability of device used in the measure, control laboratory).
XGT Panel, iXP70-TTA /AC, iXP80-TTA /AC and iXP90-TTA /AC, is made to meet the above standard.
12.2.2 Selection of XGT Panel
(1) iXP70-TTA/AC, iXP80-TTA/AC, iXP90-TTA/AC
Because the Power module whose rated input voltage is AC100-240V has danger voltage (voltage of more than 42.4V),
the product which is suitable for CE mark is having the improved insulation between internal 1 and 2.
(2) iXP50-TTA/DC, iXP70-TTA/DC, iXP80-TTA/DC, iXP90-TTA/DC
The I/O module under DC12V exceeds the range of low voltage command target.
To Next Page
Loading...