Chapter 3. Standard Specification
(1) Caution in power connection
: With AC power applied to DC power device, it may cause product damage or fire.
Please pay a special attention to connection.
(2) FG Connection
: For the device FG, please use ⑤ FG terminal in the Chapter 2.1, which is FG terminal for extended FG card.
(3) Battery discharge-preventing tape and DIP switch
: Tape is attached to prevent battery discharge. To use backup function, please remove the tape and turn on
DIP switch No. 3.
(4) Battery Operation and Life
: Battery is used for backup data maintenance and RTC (date/time) when the power of device is off. It is used only
when power is Off. Battery is not consumed with power applied. If battery is discharged, Super-Cap is used for
8 days for backup data maintenance and RTC (date/time) with power off
(5) LCD Backlight Replacement
: Please replace LCD if you want to replace LCD backlight.
(6) Caution in Audio Output
: Unamplified speaker without the volume adjustment function such as earphone, headset, etc. may make a small
sound output through LINE-OUT.
(7) Protection Standard
: Protection Standard of XGT Panel is designed to suit for IP65 condition under the IEC60529(Degrees of protection
provided by enclosures).
Although the front of XGT Panel that is installed on the panel suits for Protection Standard, it does not guarantee
about all circumstances of installation. Please refer to Chapter 10. Installation and Wiring about installation.
(8) USB memory file system standard
: USB memory has to format as FAT or FAT32.
To Next Page
Loading...