LSIS iXP Series - Page 85

Chapter 10. Installation and Wiring
10-5
Remark
(1) Use the gasket to prevent dust or other contaminant ingress.
(2) When you mount the XGT Panel on the panel, if the surface of panel is uneven, water or dust can enter the product
through the gaps. This can be caused by the quality of the material (iron, aluminum, or acrylic) or the thickness, so check
the installation environment carefully. Moreover, be sure to adhere the gasket and panel.
(3) If the gasket is damaged when you install the product or is deteriorated after a long period of use, it may weaken the
protection from water and dust ingress. If you need to replace it, contact the agency or a service center.
(3) Installation location
 When installing the XGT Panel, consider screen and use of touch.
 When you don’t see within the following angle, you may not see clearly. When installing, consider angle.
Item
Left and Right
Upper
Lower
iXP50-TTA
80 deg.
80 deg.
60 deg.
iXP70-TTA
80 deg.
60 deg.
80 deg.
iXP80-TTA
80 deg.
60 deg.
80 deg.
iXP90-TTA
80 deg.
60 deg.
80 deg.
(4) Fixation
 Fix XGT Panel to the panel using the supplied brackets provided in the OEM packaging.
Panel
Affix using supplied brackets
Affix using
supplied brackets
Affix using
supplied brackets
Affix using supplied brackets