N10 PLUS
8
facilitates you to get familiar with the lidar and helps to shorten the project
development cycle. At present, LSLiDAR only provides SDK for Linux, ROS, and
Windows X86. We will release versions for Android, Mac OS, and other
platforms later. Please follow the official website of LSLiDAR for the latest
information.
5.1 Point Cloud Display Software on Windows
This section introduces the point cloud display and software usage of N10 PLUS
lidar on Windows OS. This point cloud display software can be used for
parameter configuration, simple lidar testing, etc.
5.1.1 Software Interface Introduction
The software interface contains a menu area, a toolbar area, a 3D view area, a
data table area, a company website link, etc.
Click the icon to open the software. The initial interface is shown below
Figure 5.1 Software Interface
5.1.2 Software Operation
Choose the designated serial port to receive data. After the connection
of lidar’s power supply and serial cable, click to receive the data in real-time.
The data table contains PointID, Points_m_XYZ, Azimuth, Distance, Intensity,
Laser_id, and timestamp. PointID is the point number and Points_m_XYZ is the
To Next Page
Loading...