LSLIDAR N10 PLUS - Interface and Connectivity; LIDAR Base Connector; Adapter Board

N10 PLUS
4
1.5 Interface Definition
The specification of N10 PLUS’s base connector is A1257H-5P (male),
A1257WR-S-5P-LCP (female).
1.5.1 LiDAR Base Connector
Figure 1.5 Lidar Base Connector
Figure 1.6 Lidar Cable
Table 1.2 Wire Definition
S/N
PIN
Color
Definition
Minimum
Recommended
Maximum
1
GND
Black
Power-
0V
0V
0V
2
TX
Yellow
Lidar data output
0V
3.3V
3.5V
3
RX
Green
Function control
0V
3.3V
3.5V
4
VCC
Red
Power+
4.75V
5V
5.25V
5
NetP1_1
Blue
Connect to the
lidar shell
-
-
-
1.5.2 Adapter Board
A TTL to Type-C USB adapter module is available for the N10 PLUS series lidar
to enable TTL to USB data conversion. This adapter board is not a necessary
accessory for lidar operation. The function of each interface of the adapter board
is described as follows.