User Manual of 89XX-R Series NVR
152
Figure 11. 27 Advanced Settings Interface
2. Check the checkbox of the Enable Virtual Host.
3. Click the Save button to save the setting.
4. Enter the IP camera management interface of NVR. The Connect column appears on the right-most side of
the camera list, as shown in the Figure 11. 28.
Configuration > Remote Configuration > Camera Management > IP Camera
Figure 11. 28 Connect to IP Camera
5. Click the link and the page of IP camera management appears.
11.3 Checking Network Traffic
Purpose:
You can check the network traffic to obtain real-time information of NVR such as linking status, MTU,
sending/receiving rate, etc.
Steps:
1. Enter the Network Traffic interface.
Menu > Maintenance > Net Detect
To Next Page
Loading...
