User Manual of 89XX-R Series NVR
43
3.2 Operations in Live View Mode
In live view mode, there are many functions provided. The functions are listed below.
•
Single Screen: showing only one screen on the monitor.
•
Multi-screen: showing multiple screens on the monitor simultaneously.
•
Auto-switch: the screen is auto switched to the next one. And you must set the dwell time for each screen on
the configuration menu before enabling the auto-switch.
Menu>Configuration>Live View>Dwell Time.
•
Start Recording: continuous record and motion detection record are supported.
•
Output Mode: select the output mode to Standard, Bright, Gentle or Vivid.
•
Add IP Camera: the shortcut to the IP camera management interface.
•
Playback: playback the recorded videos for current day.
•
Aux Monitor: the NVR checks the connection of the output interfaces to define the main and auxiliary output
interfaces. The priority level for the main and aux output is HDMI1/VGA>HDMI2.
When the aux output is enabled, the main output cannot perform any operation, and you can do some basic
operation on the live view mode for the Aux output.
3.2.1 Front Panel Operation on Live View
Table 3. 2 Front Panel Operation in Live View
Functions Front Panel Operation
Common Menu
Quick access to the sub-menus which you frequently visit. Up to 5 sub-menu
options are supported.
Menu Enter the main menu of the system by right clicking the mouse.
Show single screen Press the corresponding Alphanumeric button. E.g. Press 2 to display only the
screen for channel 2.
Show multi-screen Press the PREV/FOCUS- button.
Manually switch screens
Next screen: right/down direction button.
Previous screen: left/up direction button.
Auto-switch Press Enter button.
Playback Press Play button.
Switch between main
and aux output
Press Main/Aux button.
3.2.2 Using the Mouse in Live View
Table 3. 3 Mouse Operation in Live View
Name Description
Common Menu Quick access to the sub-menus which you frequently visit.
Menu Enter the main menu of the system by right clicking the mouse.