LTS LTN8932-R - Initializing Hdds

User Manual of 89XX-R Series NVR
159
12.1 Initializing HDDs
Purpose:
A newly installed hard disk drive (HDD) must be initialized before it can be used with your NVR.
Steps:
1. Enter the HDD Information interface.
Menu > HDD> General
Figure 12. 1 HDD Information Interface
2. Select HDD to be initialized.
3. Click the Init button.
Figure 12. 2 Confirm Initialization
4. Select the OK button to start initialization.
Figure 12. 3 Status changes to Initializing
5. After the HDD has been initialized, the status of the HDD will change from Uninitialized to Normal.
Figure 12. 4 HDD Status Changes to Normal
Initializing the HDD will erase all data on it.