User Manual of 89XX-R Series NVR
164
Figure 12. 12 Storage Mode Interface
3. Click the Apply button and the following Attention box will pop up.
Figure 12. 13 Attention for Reboot
4. Click the Yes button to reboot the device to activate the changes.
5. After reboot of device, enter the HDD Information interface.
Menu > HDD> General
6. Select HDD from the list and click icon to enter the Local HDD Settings interface, as shown in Figure 12.
14.
Figure 12. 14 Local HDD Settings Interface
7. Select the Group number for the current HDD.
The default group No. for each HDD is 1.
8. Click the OK button to confirm the settings.
To Next Page
Loading...
