Lubeworks 18063521 - User Manual

Questions and Answers

J
Jeffrey BooneAug 5, 2025
What to do if the Lubeworks Control Unit has slow or no fluid flow?
- R
  rmartinAug 5, 2025
  If you experience slow or no fluid flow with your Lubeworks Control Unit, it could be due to several reasons: a clogged filter, low pump pressure, a shut-off valve not fully open, or foreign material jammed in the metering element. First, relieve the pressure. Then, loosen the swivel fitting and clean or replace the filter. If the problem persists, it may require professional attention.
H
hbowenAug 11, 2025
Why is my Lubeworks Control Unit leaking oil from the swivel?
- M
  Mrs. Jessica Gray DDSAug 11, 2025
  Oil leaks from the swivel of your Lubeworks Control Unit can occur if the swivel is loose or if the O-ring is worn or damaged. Try torquing the swivel. If the leak continues, replace the O-ring. If the problem still remains, further assistance may be needed.
S
Susan GallagherAug 16, 2025
What to do if Lubeworks Control Unit valve leaks?
- J
  Jeffery GrossAug 17, 2025
  If the valve on your Lubeworks Control Unit is leaking, it's likely that the O-rings or valve seat are worn or damaged. You should replace the O-rings and/or the valve seat. If the problem persists, it may require professional attention.
S
Sarah ChenAug 23, 2025
How to fix oil drips from the Lubeworks Control Unit nozzle?
- D
  Dillon WalshAug 25, 2025
  If oil is dripping from the nozzle of your Lubeworks Control Unit, inspect the nozzle for damage or obstructions. If you find any damage, replace the nozzle. If the problem still remains, further assistance may be needed.
B
Brian HallAug 29, 2025
How to correct a wrong reading on the Lubeworks 18063521 Control Unit?
- P
  pachecojenniferAug 29, 2025
  If your Lubeworks Control Unit is showing a wrong reading, this could be due to a correction coefficient error. Reset the correction factor (follow the instructions on Page 6)