Backup Programming—Automatic (#123)
5-43
Changing the Setting
To change the setting for Backup Programming—Automatic:
1. Press
f 0 0 s s# 1 2 3 at extension
10 or 11.
The current setting is displayed.
2. Press D or d to change the setting, or press r to return
the setting to the default.
3. Exit programming mode.
If you chose Option 1, Active:
The system will be backed up to the PC Card at 2:00 a.m., and thereafter at
2:00 a.m. on the first day of each month, provided that a valid
Backup/Restore PC Card is in the PC Card slot. (See
PARTNER PC Card
Installation Instructions
.)
The old
AUTO.
mmddyy file on the PC Card is replaced by the new one.
(The
MAN.
mmddyy file is unaffected.)
You can use the
Restore
Programming (#125)
feature to check the date on the
AUTO.
mmddyy file
to verify that the backup was successful.
If you chose Option 2, Not Active, no automatic backups will be performed.
For information about using Option 3, Backup Alarm Cleared, see‘‘Clearing a
Backup-Failure Alarm’’ on page 6-3.
To Next Page
Loading...
Need help?
General
