Disallowed List Assignments (#405)
5-113
Disallowed List Assignments (#405)
Description
This System Programming procedure lets you assign up to eight Disallowed
Phone Number Lists to specified extensions.
Related Features
You must use Disallowed Phone Number Lists (#404) to create the lists of
disallowed telephone numbers
before
you use this procedure.
Considerations
When a Disallowed Phone Number List is assigned to an extension, the list
applies to
all
lines to which the extension has access.
Valid Entries
1 = Assigned to extension
2 = Not Assigned to extension
✔
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
as
s and e on system phones.)
To assign Disallowed Phone Number Lists to an extension:
1. Press
f 0 0 s s # 4 0 5 at extension
10 or 11.
2. Enter the number of the extension to be programmed. For example, to
program extension 27, press
2 7. A display similar to the following
appears:
Disallow To 27
List Number:
3. Enter the list number (1–8). For example, to select list 1, press
1.
4. To assign or unassign the list, press
D until the appropriate value
displays.
5. At this point:
â– To assign or unassign another list for this extension, press n
or
p
until the list number shows on the display. Then repeat Step 4.
â– To program another extension, press N or P
and begin at Step 2.
6. Select another procedure or exit programming mode.
To Next Page
Loading...
Need help?
General
