Feature Reference
5-268
System Time (#103)
Description
This System Programming procedure sets the time that appears on system
display phones.
Related Features
■ Backup Programming—Automatic (#123) uses the System Time to
schedule the automatic backups.
■ Backup Programming—Automatic (#123) and Backup Programming—
Manual (#124) do not backup the System Time.
■ Restore Programming (#125) does not restore the System Time.
Considerations
■ Be sure that the System Time is set correctly before using backup or
restore procedures.
■ Enter the time in 24-hour notation. In this scheme, the hours of the day are
0000 (12 midnight) to 2359 (11:59 p.m.). Since each time must have four
digits, use leading zeros when necessary. For example, to set the time to
9:00 a.m., enter
0 9 0 0. For 4:45 p.m., enter 1 6 4 5.
■ The time appears on system display phones as a.m. or p.m. (not in 24-hour
notation).
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
as
s and e on system phones.)
To change the System Time:
1. Press
f 0 0 s s # 1 03 at extension
10 or 11.
2. Enter a new time in 24-hour notation. For example, to set the time to
2:15 p.m., press
1 4 1 5. A display similar to the following appears:
System Time
Data 1415
This time appears on system display phones as 2:15 p.
3. Select another procedure or exit programming mode.
To Next Page
Loading...
