Direct Extension Dial Lines (#205)—Release 2.0 or
Later
5-105
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
as
s and e on system phones.)
To identify the lines on which outside calls should be answered for Direct
Extension Dial:
1. Press
f 0 0 s s # 2 0 5.
2. Enter the desired system line number. For example, to specify line 1, press
0 1.
3. To assign or unassign Direct Extension Dial, press
D until the
appropriate value displays.
4. To specify another line, press
n or p until the line number
shows on the display. Then repeat Step 3.
5. Repeat Steps 3 and 4 for all desired lines.
6. Select another procedure or exit programming mode.
To Next Page
Loading...
Need help?
General
