Forced Account Code Entry (#307)
5-139
Considerations
■ If SMDR is used, the account code assigned to incoming or outgoing calls
prints on call reports. (See ‘‘Call Reporting Devices (SMDR)’’ on page 4-9 for
more information about call reporting.) For forced account code entry, if a
Forced Account Code List exists, only valid account codes are printed on
the call report.
■ Forced account codes are not required to answer incoming calls at the
extensions programmed with this feature.
Valid Entries
1 = Assigned
2 = Not Assigned
✔
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
as
s and e on system phones.)
To program an extension for Forced Account Code Entry:
1. Press
f 0 0 s s # 3 0 7 at extension
10 or 11
.
2. At the
Extension:
prompt, enter the number of the extension to be
programmed. For example, to program extension 15, press
1 5
.
3. To assign or unassign Forced Account Code Entry, press D until the
appropriate value displays.
4. To program another extension, press
n or p until the
extension number shows on the display. Then repeat Step 3.
5. Select another procedure or exit programming mode.
To Next Page
Loading...
