Feature Reference
5-142
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
as
s and e on system phones.)
To create a Forced Account Code List:
1. Press
f 0 0 s s # 4 0 9 at extension
10 or 11.
2. Select a list entry (01–99). For example, to select the third entry, press
0
3. A display similar to the following appears:
Forced Act Code List 03
Data - - - - - - - - - - - -
3. Enter up to six digits for the list entry.
4. If the account code is five digits or less, you must press
e to save the
account code in memory.
5. At this point:
■ To enter other account codes, press n to select a different list
entry and repeat Steps 3 and 4.
■ To change the account code you just entered, press r and
repeat Steps 3 and 4.
■ To delete the account code you just entered, press r.
6. Select another procedure or exit programming mode.
To Next Page
Loading...
