Manual Signaling (F13XX or F13*XX)
5-189
â– A Manual Signaling button does not initiate an intercom call unless you lift
the handset or press
S, press i, and then press the Manual
Signaling button.
â– To respond to a signal, the target extension must place an intercom call to
the person signaling.
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
as
s and e on system phones.)
To program a Manual Signaling button:
1. Press
f 0 0 s s c at extension
10 or 11.
2. Enter the number of the extension to be programmed with this feature.
3. Press a programmable button.
4. Press
f 1 3.
5. Dial the two-digit extension number of the target extension. For example, to
identify extension 22 as the target extension, press
2 2. (Enter * before
the extension number if you want to use the button for voice signaling.)
6. Program another button for this extension or exit programming mode.
Using
â– To beep the target extension:
1. While the handset is in the cradle, press the programmed button.
The extension beeps for as long as the button is pressed.
â– To ring or voice signal the target extension:
1. Lift the handset or press
S.
2. Press
i.
3. Press the programmed button.
â– To transfer a call to the target extension:
1. While active on the call, press
&.
2. Press the programmed button.
To Next Page
Loading...
Need help?
General
